The X-T3 brings a bunch of adjustments and enhancements over earlier X-series cameras. Its new sensor and processor allow a lot quicker efficiency and vital function enhancements for each stills and video. 

Let’s begin with what it’s and what it is not. The X-T3 shouldn’t be an all-new digicam. It would not function a revolutionary new gap within the entrance of the physique or a lonely card slot for us to argue over. It’s a strong improve to an already nice sequence of cameras. It does that exceptionally effectively. We’ll take a look at it from that standpoint. 

Because the digicam has been out for a couple of weeks now, lots of you’ll be aware of the specs, however let’s take a second to recap a number of the headline adjustments. There’s a brand new sensor, a brand new processor, full-sensor PDAF protection, 30 fps blackout-free capturing, and 4K at 60 fps. We additionally get the bigger EVF discovered within the X-H1, which is nice. It is a greater replace than it’d first have appeared. 

The First Firmware Replace

Being within the fortunate place that we’re, we acquired the X-T3 per week earlier right here in South Korea because of an enormous nationwide vacation proper on the worldwide launch date. Thus, I had the possibility to expertise a brand new digicam full with a lockup bug that was fortunately mounted simply after the worldwide launch. Since then, I haven’t had any points. In case you resolve to buy one, I like to recommend ensuring you replace to firmware 1.01 as quickly as you get your digicam. Let’s soar into the assessment. 

The New Sensor

The X-T3 accommodates the fourth era of X-Trans sensor from Fujifilm. Nonetheless made by Sony, not by Samsung as was rumored, the backside-illuminated, 26-megapixel sensor presents barely extra decision than the earlier era. It’s not the little further resolving energy that makes this sensor particular, nonetheless. It’s the 100-percent part detect autofocus protection and readout speeds.

Autofocus Protection 

Whereas earlier X-Trans sensors solely had PDAF in a sq. or rectangle within the center and relied on distinction detect for the edges of the picture, the brand new sensor has 425 PDAF sensors that cowl your entire body. 

In observe, this brings about a number of advantages. It signifies that your entire body can be utilized for all autofocus varieties. Not do you must fear that the topic you are monitoring may stray from the middle of the body. Face/eye detection additionally works effectively throughout the entire body. We’ll speak extra about this within the autofocus part of this assessment.

The New Processor

Quad core CPU

Fujifilm has been capable of scale back energy consumption whereas bettering efficiency with the brand new X-Processor 4. Autofocus and publicity calculations are actually performed utterly independently, which improves their efficiency considerably. Whereas this sounded nice once they made the announcement, it wasn’t till getting my arms on the X-T3 that I actually appreciated the distinction. 

In observe, this implies you’ll not want enhance mode or the vertical grip to get probably the most out of the digicam. All capabilities are enabled by merely switching the digicam into enhance. An EVF refresh of 100 fps is now potential with out the grip, so realtime publicity adjustments look a lot smoother. The opposite good thing about separating the publicity from the AF is that autofocus for all lenses is now a lot improved. In reality, with the autofocus processor now being able to 240 calculations per second, you’ll discover an enormous enhance, even with older lenses. 

As we noticed with the X-T1 and X-T2, the complete energy of the processors wasn’t realized at launch. If that observe report is something to go by, we must always see some wonderful updates coming to the X-T3 by way of firmware as effectively.

Readout Pace

Fujifilm claims that the brand new sensor and processor mixture permits for 1.5x the readout velocity of the X-T2. As we all know, CMOS sensors learn their information sequentially, so studying it quicker will end in much less rolling shutter for video and digital shutter customers. I’ve observed an enchancment in capturing stills particularly. With the X-T2, I’d keep away from utilizing the digital shutter for something the place I or my topic could be transferring. Nonetheless, with the X-T3, I can extra confidently make use of the silent shutter for issues like road images. It nonetheless leads to slight warping with fast paced topics like youngsters, so I can not apply it to household classes simply but. 

Dealing with

There aren’t too many adjustments within the dealing with division, which is a good factor. The X-T2 is a splendidly snug digicam to carry and work with, so small refinements are sufficient. 

The AE-L, AF-L, Playback, and Delete buttons have all barely elevated in measurement and are barely extra distinguished. This makes them simpler to seek out and push than their X-T2 counterparts. This has been helpful when locking publicity and focus to make panoramas. Whereas usually, I’d swap the X-T2 into full guide mode to make a panorama, now I’m capable of maintain the lock buttons in simply whereas I transfer the digicam to make the photographs.

One different measurement change is the publicity dial, which is now smaller and extra recessed. It has additionally grow to be somewhat stiffer to show, now requiring two fingers to rotate it. Presumably, this was performed to cease it from being knocked and turned, however I actually choose the dial from the X-T2, which I by no means knocked misplaced. Having the ability to flip it with simply my thumb made for a fast and straightforward capturing expertise. Your mileage could fluctuate. 

One probably welcome change for a lot of is a lock on the diopter dial. You’ll must pop the dial out as a way to change its worth now. That is one dial I’ve had points with prior to now. I’ve had a couple of occasions after I’ve pulled the digicam out of my bag solely to seek out that the viewfinder was a whole blur regardless of the digicam locking focus. 

Lastly, one other change that can please many video or tethering customers is the detachable port door. By unlocking the highest of the hinge on the door masking the I/O ports, you possibly can take away it to make room for bigger jacks and make sure the door doesn’t get damaged throughout use. 

Maybe the one dealing with function that stands out as being an enormous change is the touchscreen. It capabilities as you’d anticipate. You possibly can transfer the main focus level round while you’re trying by the EVF, use it to make pictures, and work with the fast menu. In case you’re a touchscreen fan, this may absolutely be a welcome change. It’s responsive and provides you another option to management the digicam.

As I discussed above, most of those are small adjustments that can profit some customers greater than others. Nonetheless, these little issues convey one other degree of refinement to the X-T3. 


With the brand new processor and sensor in place, the X-T3’s autofocus seems like a totally revamped digicam. Though all of the performance you’re used to with the X-T2 continues to be there, the velocity and fluidity takes this digicam right into a league of its personal. 

I’ve performed some fundamental testing in a real-world scenario to get an concept of how effectively the X-T3 performs when in comparison with the X-T2. As you’ll see within the video under, the X-T3 outpaces it considerably and reduces searching to virtually nothing when working in single level autofocus on an overcast day. At evening, the hole closes considerably, however the X-T3 nonetheless hunts lower than the X-T2. You may as well see these exams right here.

The face detection works rather a lot higher now. With the X-T2, it was fairly gradual and sometimes did not discover faces. Now, you will discover it locks on fairly effectively and can discover all of the faces in a given scene (though you continue to cannot choose between them). AF-C monitoring additionally works extraordinarily effectively with face detection turned on and surprisingly, the older lenses additionally do a a lot better job with this now. 

This week I had a college portrait session to {photograph}. I had a wide range of face varieties in addition to youngsters with glasses and hair masking components of their faces to work with. All this was performed in a dim room, so it was an actual problem for the X-T3. Over the course of 170 college students and 15 lecturers, the face-detect AF solely missed deal with 5 pictures and couldn’t discover one face for a couple of moments earlier than locking again on once more. In a dimly lit surroundings with fast-moving topics, I’d not usually have taken my XF 35mm f/1.4 or XF 56mm f/1.2 and would have opted for one thing quicker just like the XF 35mm f/2 and XF 50mm f/2 as substitutes. Nonetheless, with the X-T3, I didn’t discover myself wanting for the newer lenses in any respect. 

In one other session, I made a couple of backlit portraits on the finish of the day. I knew this is able to be an excellent take a look at of the brand new autofocus system, because the X-T1 would have failed utterly and the X-T2 would have struggled on this scenario. Actually, I wasn’t anticipating an excessive amount of of an enchancment. Backlight is difficult for any autofocus system. Nonetheless, the X-T3 locked on to the mannequin’s face utilizing face detection, even in profile. There have been a few occasions when it struggled and returned focus failure, however only some out of the 50-or-so pictures we made on this scene. 

When utilizing AF-C, I discovered that the older lenses, such because the XF 56mm f/1.2, now lock on and observe about in addition to the XF 16-55mm and XF 50-140mm. That being stated, the professional zooms are actually lightning quick, and I haven’t seen a missed body but that wasn’t my fault. For video work as effectively, corresponding to interviews, this may a wonderful enchancment for positive. 

General, I’d say that you simply get a extra assured autofocus system that improves the velocity and accuracy with all lenses. The older f/1.Four lenses have seen a brand new lease on life but once more, and the newer zooms are actually up there with the fastest-focusing lenses I’ve ever used. Hats off to the Fujifilm engineers once more. The autofocus enhancements alone are definitely worth the improve for my work.


If the X-H1 was Fujifilm’s try and make a extra severe competitor within the video realm, the X-T3 is taking that to new heights. With the addition of as much as 400 Mbps video utilizing the HEVC codec, you’ll now have the ability to seize extra information than ever earlier than. Not solely this, however you’ve bought 4K 60p in each 16:9 and 17:9 with each 4.2.0 (inner) and 4.2.2 (exterior) recording. 

We additionally now have the Eterna profile, which appears to have been barely tweaked. Colours appear somewhat richer, which makes it nice for stills in addition to video. The X-T3 additionally information F-Log internally for many who need to get extra severe with their grading. 

Though I dabble with video, I’m certainly not an professional. Jordan from DPReview TV has a wonderful rundown of his ideas on the X-T3 as a severe video digicam of their assessment. I’ve included it under so you possibly can take a look. 

Battery Life

Right here’s the place I get to be unpopular once more. Fujifilm cameras have all the time shattered their CIPA scores for me. With the X-T2, I’m able to get between 500 and 1,500 pictures relying on how a lot chimping I do and if I’m utilizing steady launch or not. With the X-T3, I used to be bitterly dissatisfied on my first few runthroughs. Maybe it was the best way I used to be working with the digicam, however I used to be solely getting 250-300 pictures per cost. That has modified although as I exploit it for my day-to-day work, and I’m now fortunately getting round 1,000 pictures per battery. For instance, within the college portrait session above, I made 3,800 pictures and solely used 4 full batteries, with my fifth having 72 % remaining by the top of the session. No complaints from me there.


One ultimate level price mentioning is the value right here. Fujifilm have introduced the X-T3 in at $1,499 in the USA. That makes it cheaper than the X-T2 at launch. With all these updates, that is an amazing value for this digicam.

In Conclusion

What I Preferred

  • General operational velocity
  • Blazing quick autofocus
  • Face detection rather more efficient
  • Eterna movie simulation
  • Refined over the X-T2, not redefined
  • No want for the vertical grip now
  • Value

What Might Be Improved

  • Publicity compensation dial
  • Having the ability to choose from a number of faces in face-detection mode

The X-T3 is quicker in each approach than the X-T2. It additionally takes the gorgeous screens from the X-H1 and presents some refinements that make it even simpler to make use of. In case you’re on the fence, I like to recommend hopping into your native supplier and testing out the digicam for your self. It was getting it in my arms that satisfied me on this improve. In case you’re an X-H1 consumer and you’re keen on the IBIS, you may need to await the X-H2. The brand new processor ought to make that digicam one thing particular as effectively. In case you’d like to select up and X-T3 now, head over and snag yours right here.

I will be again subsequent week with a deeper look into a number of the new options of this digicam, so keep tuned! When you have any questions within the meantime, please depart them within the feedback under. 


fbq(‘init’, ‘938393452883301’);
fbq(‘track’, “PageView”);(function(d, s, id) { var js, fjs = d.getElementsByTagName(s)[0]; if (d.getElementById(id)) return; js = d.createElement(s); = id; js.src = “”; fjs.parentNode.insertBefore(js, fjs); }(document, ‘script’, ‘facebook-jssdk’));

Shop Amazon